Tysso BCP-5500 Series, Руководство пользователя

Страница: 14 / 60

-12-
The pre-installed battery of the data collector is fully charged and tested in
factory. To maximize the capacity and lifespan* of the battery, user should
not store, charge or operate the battery under overheat temperature,
moisture environments.
*Note: The Lifespan of the rechargeable battery may vary depending on
operating conditions.
3.2.1 Battery Replacement
After the rechargeable battery operating under normal conditions after
hundreds of charge-discharge cycles, the lifespan of the battery will
decrease. When the battery nears the end of its usable life, it is necessary
to replace a new battery**.
Before replacing the battery, turn off the data collector (press and hold the
scan trigger for over 5 seconds until the display is off) and unplug the cable.
1. Use a screw driver to loosen the securing screw of the back cover.
2. Remove the back cover.
3. Pull and remove the used rechargeable battery.
4. Replace with a new battery and re-install the back cover.
5. Secure the screws of the back cover with screw driver.
**Note: Use only the authorized battery and have the battery replaced only
by an authorized service provider.
3.2.2 Battery Disposal
Recycle or dispose of used battery as stipulated by local regulations.
4 Operating Your Data Collector