Tylo H2, Руководство пользователя и инструкция по установке

Страница: 7 / 60

5
The panel can be set to automatically lock the buttons. Locking
can be performed with or without a code.
To program automatic keylock:
1. Select Settings .
2. Select General .
3. Select Keylock .
4. Select Activate with code or Activate without code depend-
ing on whether a code is needed.
If selecting
Activate with code the code should be changed.
Change code by selecting Set code . Enter the existing code
first (default is 0000) and then the new code. Confirm the new
code.
NOTE! If the panel is code-protected, an external
switch connected to the panel will still work. For this
function, see The section called External ON/OFF
switch (option) , Page 5.
To enter how long it takes before the panel automatically locks:
1. Select Settings .
2. Select General .
3. Select Keylock .
4. Select Delay .
5. Enter the time until panel lock (10 sec. - 5 min., default is 15
sec.).
Drying mode
Once operating time expires or the heater is switched off via OFF ,
the sauna will start drying (if the water reservoir has been in use,
humidity setting 1-10). Drying is active for 20 minutes, after which
the heater will switch off. The drying mode can also be cancelled
manually by pressing OFF . The drying mode will be shown in the
status bar by ON/OFF STATUS changing to DRYING STATUS
(see Figure 13, Page 5).
Figure 13: DRYING STATUS
External ON/OFF switch (option)
General
External ON/OFF switches are available with impulse or constant
activation. The control panel detects automatically which activa-
tion is used. However, the switch function can vary depending on
activation. Switches with constant activation can only use the On/
Off function. Impulse switches can be given various functions, de-
pending on whether they can be programmed with On/Off or Ex-
tended bathtime .
On/Off
On/Off
(impulse and constant activation, not suitable for calendar
programming)
Switches with constant activation:
• To run the system for a preprogrammed time in
External
switch bathtime : press the switch once.
• To switch off the system, press the switch once more.
Impulse switches:
• To run the system for a preprogrammed time in
External
switch bathtime : press the switch once. (Functions if the sys-
tem is in Standby or Off .)
• To switch off the system, press the switch once more. (If the
heater is in a program, it will be shut down and wait for a new
program or new On -activation.)
Extend bathtime
Extend bathtime (with impulse only):
• To run the system for a preprogrammed time in External
switch bathtime
: press the switch once.
• To restart the time, press once more.
• When the time has expired, the heater will return to the setting
it would have been in if the switch had not be activated.
Setting a function
To set a function for impulse switches:
1. Select Settings .
2. Select Service .
3. Select Settings .
4. Select External switch function .
5. Select between On/Off and Extended bathtime .
Setting External switch bathtime
To define the sauna time for pressing the external switch:
1. Select Settings .
2. Select Service .
3. Select Settings .
4. Select External switch bathtime :
5. Enter the time and confirm with OK .
Extra control panel (option)
All connected control panels work in parallel, i.e. making a se-
lection on one panel will activate the same selection on the oth-
er connected units. However, there are certain individual settings
which do not affect running of the heater, but which are selected
on each panel:
•
Automatic keylock on/off
• Code lock on/off
• Delay time
• Vibration on/off