Tylo H2, Руководство пользователя и инструкция по установке

Страница: 5 / 60

3
Setting start time and calendar programming.
You can set a time when the heater is to start up to 24 hours in
advance. You can also set up a weekly program (activities) of
start and stop times, temperature, which days the program ap-
plies to (up to one week in advance) and select whether the activ-
ity should be repeated or not.
To set up a start time:
1. Select TIMER (see Figure 6, Page 3).
Figure 6: TIMER and TIMER STATUS
2. Press OK .
3. Select Timer .
4. Select Start time .
5. Enter the start time and set the correct time. Use UP / DOWN
to increase or decrease the value. Confirm each digit with OK.
When a time is programmed, TIMER STATUS (see Figure 6,
Page 3) is shown in the STATUS BAR in the main menu.
To activate a preprogrammed time:
1. Select TIMER .
2. Select Activate .
3. Confirm with OK .
To activate a program:
1. Select TIMER .
2. Select Activate .
3.
Confirm with
OK
.
To set up a weekly program (an activity):
1. Select TIMER .
2. Press OK .
3. Select Calendar .
4. Select New activity .
5. Enter start time, end time, temperature, humidity, activity type
(
On
or
Standby
), the day(s) the activity applies to and wheth-
er the activity should repeat every week. Use UP/DOWN to in-
crease/decrease a value, and confirm with OK .
Key to activity type:
On
means that the set temperature/humidity will be used.
If Standby is selected, the temperature will be reduced by a
predefined number of degrees (default 20 °C). When users
enter the sauna, they press the external switch or control
panel and the sauna will quickly heat up to the temperature
set. Standby is indicated on the control panel by STANDBY
STATUS (see Figure 7, Page 3).
Figure 7: STANDBY STATUS
When choosing a day, every day of the week will be shown.
Use the UP / DOWN arrows to select which day the activity will
apply to, and confirm with OK . More than one day can be se-
lected. The days selected will be indicated by a mark on the
right.
When the day/days have been selected, go down to
> and
confirm with the OK symbol. Select whether the activity will ap-
ply to this week or all weeks. When an activity is set up, it is
shown by CALENDAR STATUS (see Figure 8, Page 3)
appearing in the status bar.
Figure 8: CALENDAR STATUS
Several activities can be set up. When the first activity is ready
and you want to set up a new one, select New activity in the cal-
endar menu. Up to 30 activities can be set up.
To edit an activity:
1. Select TIMER .
2. Select CALENDAR .
3. Select the activity you want to edit.
4. Select Edit .
5. To edit your choice, see The section called Setting start time
and calendar programming. , Page 3, Set up a weekly
program (an activity) step 5.
To delete an activity:
1. Select TIMER .
2. Select CALENDAR .
3. Select the activity to delete.
4. Select Remove .
5. Select Yes .
6. Confirm with OK .
The SETTINGS menu
There are extra functions in the SETTINGS (see Figure 9, Page
3 to enter various parameters. You can also reset the control
panel to factory settings under this menu.
Figure 9: SETTINGS
SETTINGS has the following sub-menus:
• Sauna
• General : You can set a range of parameters here, such as
time, date, language etc.
•
Service
: You can change the default parameters under the
service menu.