Tyger ARMOR TG-AM2F20098 Скачать руководство пользователя страница 1

TM

Customer Support  1-866-340-3038

1/4

    

Parts List

Driver Side Armor     

Passenger Side Armor       

10mm x 27mm OD x 3mm Flat Washers

x1

x1

x36

10mm Hex Nuts

x12

10-1.5mm x 30mm Hex Bolts

10mm Clip Nuts

10mm Lock Washers

x24

x12

x24

TG-AM2F20098

Front 

Driver/Left Side Armor 

Assembly 

Passenger/right Side 

Armor Assembly 

Front 

1-866-340-3038

www.tygerauto.com

[email protected]

TYGER ARMOR

TM

Warning

To protect your investment, wax this product after installing. Regular waxing is 

recommended to add a protective layer over the finish. Do not use any type of polish 

or wax that may contain abrasives that could damage the finish. Use only mild soap 

to clean the Side Armor.

Before Installation

REMOVE CONTENTS FROM BOX. VERIFY ALL 

PARTS ARE PRESENT. READ INSTRUCTIONS 

CAREFULLY BEFORE STARTING INSTALLATION. 

ASSISTANCE IS HIGHLY RECOMMENDED.

Содержание ARMOR TG-AM2F20098

Страница 1: ...ont 1 866 340 3038 www tygerauto com support tygerauto com TYGERARMOR TM Warning To protect your investment wax this product after installing Regular waxing is recommended to add a protective layer over the finish Do not use any type of polish or wax that may contain abrasives that could damage the finish Use only mild soap to clean the Side Armor BeforeInstallation REMOVE CONTENTS FROM BOX VERIFY...

Страница 2: ...be covered with sealing tape or insulation STEP1 Fig 1 Driver left body mounting locations along back of inner rocker panel illustrated Front Fig 2 Locate the factory holes along the pinch weld Start at the 2nd pair of factory holes Fig 3 Typical Mounting Location Factory holes in pinch weld Line up Clip Nut with factory hole Fig 4 Factory holes in pinch weld pictured from behind body panel Line u...

Страница 3: ...Hex Bolts 6 10mm Lock Washers and 6 10mm Flat Washers Figures 6 9 Do not tighten at this time STEP5 Move to the 2nd pair of holes along the pinch weld directly under the center of the front door Figures 1 2 Select 2 10mm Clip Nuts Slide the 10mm Clip Nuts into the rectangular opening with the nut towards the inside Line up the threaded nut on the clip with the round holes on each side of the recta...

Страница 4: ...6 Do not fully tighten at this time STEP6 Do periodic inspections to the installation to make sure that all hardware is secure and tight STEP9 Rear Fig 9 Driver left rear bracket pictured 2 10mm Hex Bolts 2 10mm Lock Washers 2 10mm Flat Washers 2 10mm Hex Bolts 4 10mm Flat Washers 2 10mm Lock Washers 2 10mm Hex Nuts Complete Installation Level and adjust the Side Armor properly and tighten all har...

Отзывы: