Figure 14: Opening the battery cover
Figure 15: Enrollment button and battery polarity
1. Enrollment button
2. Battery polarity
Figure 16: Pulling the battery tab
Figure 17: Closing the battery cover
7. Setting the pet immunity
The pet immunity feature allows pets to pass through the PIR curtain without triggering a false alarm.
The pet immunity selector is located in the battery compartment. See Figure 18.
Remove the battery cover and the right-hand side battery before you configure the pet selector. See
Inserting or removing the batteries
for more
information.
Choose the device mounting height and configure the pet immunity selector according to the following guidelines:
l
If you do not have a pet and do not expect other pets or rodents to enter the protected area, set the pet immunity selector to Setting 4 and mount the
detector at a height of 1.6 m/5.25 ft to 2 m/6.56 ft. The best mounting height for this setting is 2 m or 6.56 ft.
l
If you have a small pet that weighs less than 3 kg or 6.6 lb, or if there are rodents in the area, set the pet immunity selector to Setting 2 and mount the
detector at a height of between 1.8 m or 5.9 ft and 2 m or 6.56 ft.
l
If you have a pet that weighs less than 18 kg or 40 lb, set the pet immunity selector to Setting 1 and mount the detector at a height of 2 m or 6.56 ft.
Figure 18: Pet immunity selector
Pet immunity selector
l
Setting 1: Pet < 18 kg or 40 lbs (default)
l
Setting 2: Small pet < 3 kg or 6.6 lb or rodents
l
Setting 3: No function
l
Setting 4: No pet
Note:
Setting 3 in the pet mask selector has no function.
D-307164 MP-902 PG2 Installation instructions
6
