Tyco iSTAR eX, Руководство по установке и настройке

Страница: 32 / 232

iSTAR eX General Controller Module (GCM)
1–12 iSTAR eX Installation and Configuration Guide
iSTAR eX GCM LEDs
iSTAR LEDs on the GCM are labeled and indicate the following:
„
HEARTBEAT - The LED blinks rapidly while the board is waiting for a
reboot following restore-factory-default. Otherwise, the LED blinks
slowly.
„
COM1-RX – RS 485 COM1 receive data
„
COM2-RX – RS 485 COM2 receive data
„
COM1-TX – RS 485 COM1 transmit data.
„
COM2-TX – RS 485 COM2 transmit data
„
RS232-RX – RS-232 (debug port) receive data
„
RS232-TX – RS-232 (debug port) transmit data
„
ETH1 TxRx – Ethernet 1 receive or transmit data
„
ETH2 TxRx – Ethernet 2 receive or transmit data
„
ETH1 100 – Carrier - Ethernet 1 is connected to a 10/100Base network
„
ETH2 100 – Carrier - Ethernet 2 is connected to a 10/100Base network
„
RELAY1 – Relay 1 is energized
„
RELAY2 – Relay 2 is energized
„
RELAY3 – Relay 3 is energized
„
RELAY4 – Relay 4 is energized
„
OC 1 – Open collector output 1 is energized
„
OC 2 – Open collector output 2 is energized
„
OC 3 – Open collector output 3 is energized
„
OC 4 – Open collector output 4 is energized
„
SPI ACTIVE – GCM is transferring data over the SPI bus
„
PWR – Power is applied to the GCM board