Tyco iSTAR eX, Руководство по установке и настройке

Страница: 149 / 232

Setting ICU Options
iSTAR eX Installation and Configuration Guide 5–15
Changing the ICU Password
You can change the password for the ICU using the Options dialog box.
To change the ICU password
1. In the ICU User Password section of the Options dialog box, enter the
new password in the Password field.
2. Confirm the password by entering it again in the Re-Enter Password
field.
3. Click OK .
Setting the Public IP Address for Firmware Downloads
If the public IP address of the PC you are using to download iSTAR eX
firmware is different from the IP address assigned to the PC’s NIC card, enter
the public IP address of the PC in the Public IP Address field on the Options
dialog box. This is required when the PC is on a WAN located behind a NAT
server that exposes a public IP address for the PC that is different from the IP
address assigned to the PC’s NIC card. After you enter the public IP address,
click OK .
Setting the TCP/IP Port for Firmware Downloads
By default, the computer on which you are running the ICU uses port 2222 to
download firmware to the iSTAR controllers on your network. In some
situations, other applications may be using port 2222 on the PC; in that case
you must specify another port to use for firmware downloads.
To specify another firmware download port, enter the port number in the
Download TCP/IP Firmware field on the Options dialog box.
To determine if port 2222 is in use, and to determine which ports are in use on
the PC, enter the following command in a DOS command prompt window:
netstat -n
NOTE
Software House recommends that you change the default ICU password.