2. Installation
8
D-306488 WK250 Installer’s Guide
2.6 Configuring the WK250 Parameters
Enter the “
Kxx.DEV SETTINGS
” main menu on the WK250 keypad immediately after enrollment or through the
“
MODIFY DEVICES
” menu if performed at a later stage. Choose the number of the keypad device to configure and
follow the configuration instructions for the WK250 keypad. Refer to Chapter 7, section A.3 for a description on the
buttons to use for navigation and setting.
Option and Default Setting
Configuration Instructions
TAMPERS
disabled
Define the active tamper.
Option settings
:
disabled
;
all tampers
and
battery cover
.
SUPERVISION
enable
Define whether or not the control panel will monitor supervision messages sent by
the keypad (see Note).
Option settings
:
enable
or
disable.
Note:
Every 5 minutes the keypad performs a communication test session with the
control panel (i.e. "Supervision signal) to check the integrity and quality of the radio
link. If the keypad does not report a supervision signal at least once within a
predefined time, a “MISSING” trouble alert is initiated. Therefore, if you take the
keypad out of the protected premises, switch the Supervision OFF to avoid the
trouble alert.
EXIT-ENTRY BEEPS
off
Define whether the keypad will sound the exit/entry warning beeps during exit and
entry delays or not. An additional option is to mute the warning beeps only when the
system is armed “HOME”.
Option settings:
on
;
off
and
OFF @ home
.
BACKLIGHT
OFF on timeout
Define whether the keypad back lighting will remain off, on at all times or will come
on when a key is pressed and go off within 10 seconds if no further keystrokes are
sensed.
Option settings:
on
;
off
and
OFF on timeout
.
TROUBLE BEEPS
off
Under trouble conditions, the keypad sounder emits a series of 3 short reminder
beeps once per minute. Define whether to enable or disable this reminder beeping
or just disable it at night. The “night” hours are defined in the factory but are usually
from 8 PM (20:00) until 7:00 AM.
Option settings:
on
;
off
and
OFF @ night
.
SOUNDER VOLUME
medium
Define the volume level of the sounder.
Option settings:
medium
;
maximum
and
minimum