Tyco Security Products SG-System 5, Руководство по эксплуатации

Страница: 79 / 108

6.0 Options
- 79 -
Number of Flashes Reason
4 flashes Computer buffer full
5 flashes Checksum failed
6.2.2 SG-DRL5-IP Options: [2XX] - Signaling Options
Option [201]: Alarm Port Number - Channel 1
Default (3061), UDP
Use this option to set the alarm port connection number for the receiver. While the default value will suffice in environments involving just one receiver,
Option [201] can be used to differentiate receivers in a complex, multiple receiver environment. If this option is changed, transmitters communicating to
the SG-DRL5-IP must be programmed with the new port number. Communicators connected to the receiver send their signals to this port.
Option [202]: Alarm Port Number - Channel 2
Default (3071), UDP
Use this option to set the alarm port connection number for the receiver. While the default value will suffice in environments involving just one receiver,
Option [202] can be used to differentiate receivers in a complex, multiple receiver environment. If this option is changed, transmitters communicating to
the SG-DRL5-IP must be programmed with the new port number. Communicators connected to the receiver will send their signals to this port.
Option [203]: Alarm Port Number - Channel 3
Default (3081), UDP
Use this option to set the alarm port connection number for the receiver. While the default value will suffice in environments involving just one receiver,
Option [203] can be used to differentiate receivers in a complex, multiple receiver environment. If this option is changed, transmitters communicating to
the SG-DRL5-IP must be programmed with the new port number. Communicators connected to the receiver will send their signals to this port.
Option [221]: Transmitter Absent Debounce Time
Default (120)
The time, in seconds, for which a transmitter configured in supervised mode must be absent before a transmitter failure condition is reported. Valid
entries are 5-65535 seconds. The transmitter is considered absent when it hasn't received any alarm traffic or heartbeats for the duration of the trans-
mitter absent debounce time.
This is a dynamic option and will follow the profile setting it is assigned to for the associated DNIS.
NOTE: The transmitter starts in the absent condition and must be restored before using this window.
NOTE: Transmitter Absent Time should not be less than 90 seconds. For ULC Commercial Burg Installations Security Levels A1 to A4
and ULC Commercial Fire Active communication systems, this option shall be programmed as 180 seconds. For UL Commercial
Burg Installations (standard/encrypted line security), this option shall be programmed as 200 seconds.
For UL Commercial Fire installations (single communication technology) this option shall be programmed as 300 seconds.
Option [222]: Transmitter Restoral Time
Default (60)
This option determines the required time a transmitter must be present before it is registered in the Account Table and the transmitter restoral message is
sent.
This is a dynamic option and will follow the profile setting it is assigned to for the associated DNIS.
NOTE: Two heartbeats must be received from the supervised IP transmitter before the register and restoral of the communicator.
For UL Listed products, the permitted setting is 90 seconds.
6.2.3 SG-DRL5-IP Options: [3XX] - System Troubles
Option [301]: Transmitter Unencrypted Trouble
Default (Enabled)
This trouble enables or disables unencrypted event reporting. When set to Enabled, the trouble is reported. When set to Disabled, the trouble is not repor-
ted. This trouble is reported when the transmitter power cycles.
Enabled Condition reported
Disabled Condition not reported
NOTE: For UL Listed products, the permitted setting is Enabled.
S
G
-S
ys
te
m
5
O
pe
ra
ti
ng
M
anua
l