409-1993
AMP-TAPETRONIC Machine 69875 and 69875-1
Rev J
32 of 46
Tyco Electronics Corporation
Figure 26
Indexing Mechanism Conversion, Part 2
Larger Screws
From Old Holder
Chamfer
Stationary
Die
Screw
Wire
Stop
(Typ)
Wire Stop
Tube
Wire Stop Tube
Assembly
Extractor 308163-1
(For Closed End Splices)
Wire Funnel (For
Terminals,Butt Splices, or
Spare Wire Caps)
New
Lower
Tooling
Holder
A
B
16. Install the upper die and tighten screw. Be sure the offset on rear of die is seated tightly against the
bottom edge of mount.
17. Remove the screwdriver from the indexing mechanism. The mechanism will return to its normal
position.
18. Lower the tape release lever.
19. Hand–cycle the machine, as described in Section 4, until the dies begin to mate, then shift the lower
tooling holder as needed to align dies as shown in Figure 28.
