409-1993
AMP-TAPETRONIC Machine 69875 and 69875-1
Rev J
28 of 46
Tyco Electronics Corporation
A. Removal
(Figure 22)
To avoid personal injury, be sure to turn off the machine and disconnect the machine from the power supplies.
1. Remove the front guard.
2. Raise the tape release lever.
3. Depress the wire funnel and pivot it away from the die holder. It may be necessary to replace the wire
funnel or extractor, as described in Paragraph 8.2, if changing wire size or product.
4. Remove the moving and stationary dies by removing the holding screws.
B. Installation
(Figure 22)
To avoid personal injury, turn off" the machine and disconnect the machine from the power supplies.
1. Choose the correct dies for the product to be run.
2. If the wire funnel is installed, depress the wire funnel and pivot it away from die holder. If it is
necessary to replace the wire funnel, refer to Paragraph 8.2.
3. Insert moving (upper) die into die holder and tighten the screw by hand.
4. Insert stationary (lower) die into die holder and start the screw, but do not tighten.
5. Hand–cycle until pullback begins and dies have bottomed.
6. Tighten the holding screws on both dies.
Figure 22
Moving Die
Holding Screw
Stationary Die
Holding Screw
Wire Funnel
Stationary
Die Holder
Moving
Die Holder
Applicator Guard Removed for Clarity.
AlwaysKeep GuardsIn Place When
Operating the Machine.
DANGER
DANGER
