409-1993
AMP-TAPETRONIC Machine 69875 and 69875-1
Rev J
14 of 46
Tyco Electronics Corporation
Figure 12
Reel Disk
Reel
Terminals on Top of Tape
and Wire Barrels Facing
the Operator
Twist 180_
Counterclockwise
Wire Barrel Faces
Back of Machine
Loosen Two Screws
and Adjust Terminal Guide
Teeth Engage
Notches in Tape
First Terminal a Few
Positions to Left of
Crimping Position
Tape
Release
Lever up"
Applicator Guard Removed for Clarity. Always
KeepGuards in Place When Operating Machine.
7. Lower tape release lever to secure tape in position.
8. Connect the machine power supply and place the main power switch in the “ON” position.
9. Depress and release the foot switch as many times as necessary to index the first product into the
crimping area.
10. Replace the front guard before beginning production operation of the machine.
B. Unloading
To avoid personal injury, be sure to turn off the machine and disconnect the machine from the power supplies.
1. Remove front guard and raise tape release lever.
2. Remove tape from indexing mechanism.
3. Cut excess lead from tape and discard.
4. Secure end of tape to reel with masking tape.
5. Remove reel from reel support.
DANGER