409-1993
AMP-TAPETRONIC Machine 69875 and 69875-1
Rev J
12 of 46
Tyco Electronics Corporation
Figure 10
A
B
Reel
Holder
Reel Retainer
Guard Between
Reel Holder
and Machine
Mounting
Screws
Target
Area
Magazine
Holder
Magazine
Position Right Edge of Holder
Approx. 102 mm [4 In.] to the
Left of Machine
152 to 203 mm
[6 to 8 In.] Approx.
To avoid personal injury, be sure to turn off the machine and disconnect the machine from the power supplies.
1. Unlatch and open flywheel cover on rear of machine.
2. Make sure the tape release lever is in the “down” position. See Figure 11.
If machine is hand-cycled with the tape release lever in the up" position, the shear pin on the ram will be broken,
preventing further damage to the machine. Refer to Section 8 for shear pin replacement.
3. Raise the stop bar, located below the solenoid, and turn the flywheel in the direction of arrow to cycle
the machine. The clutch will release at the end of the cycle.
Turning the flywheel in the direction opposite of the arrow may cause damage to the machine.
4. Repeat Step 3 as necessary to complete the operation being performed.
DANGER
CAUTION
!
CAUTION
!
