IMPORTANT! Connect a suitable rated RF test load to the RF OUPUT
socket before connecting the unit to mains power. FAILURE TO DO SO
MAY RESULT IN DAMAGE NOT COVERED BY WARRANTY.
Never carry the RF amplifier by the front panel handle. This is provided
purely to pull the RF amplifier forward, to assist in removal from an
equipment rack.
Install the TXAMP200 in a suitable 19” equipment rack with adequate
clearance and cooling airflow. Use front-to-back rack supports on both
sides of the RF amplifier, and slide the unit into the rack. NEVER ALLOW
THE FRONT PANEL FIXINGS TO TAKE THE WEIGHT OF THE UNIT.
First, connect a suitably rated test load to the RF OUT socket on the RF
amplifier’s rear panel.
Connect the mains lead.
Switch on the mains power.
Press the ‘OK’ key for 3 seconds to enter the settings menu.
Set the RF Power Output to its minimum level. Press OK to store the
value.
Connect the RF input source and then set the RF Power Output to the
required level. Press OK to store the value.
Installation
