Package
Overview
1
2
3
Warning
and
Caution
■
If the product does not work properly, please contact your dealer or the
nearest service center. Never attempt to disassemble the camera yourself.
(We shall not be responsible for any problems caused by unauthorized
repair or maintenance.)
■
Do
not
allow
water
or
liquid
intrusion
into
the
camera.
■
In the use of the product, you must be strict compliance with the electrical
safety regulations of the nation and region. When the product is mounted on
wall or ceiling, the device shall be firmly fixed.
■
Do
not
use
camera
beyond
specified
voltage
range
.
■
Do not drop the camera or subject it to physical shock.
■
Avoid touching the camera lens.
■
If cleaning is necessary, please use clean cloth to wipe it gently.
■
Do not aim the camera at the sun or extra bright place.
■
Do not place the camera in extremely hot, cold (the operating temperature
shall be -30˚C~60˚C), dusty or damp locations, and do not expose it to high
electromagnetic radiation.
■
To avoid heat accumulation, good ventilation is required for operating
environment.
■
Please read this instruction carefully before operating the unit and keep
it for further reference.
■
All the examples and pictures used here are for reference only.
■
The contents of this manual are subject to change without notice.
Quick
Start
Guide
Network
Camera
Camera
Quick
start
guide
CD
Plastic
plug
× 4
Rubber
plug
Drill
template
Screwdriver
Tapping screw
×4
1
2
3
4
5
6
7
8
Ethernet connector
Audio input connector
Alarm input/output
Power connector
Speaker
Microphone
Micro SD card slot
Reset
►
Connecting Alarm Input/Output
Alarm Input
Installation
4
Please make sure that the wall or ceiling is strong enough to
withstand 3 times the weight of the camera. Please install and use
the camera in the dry environment.
①
Loosen the fixed screw to disassemble the camera.
Fixed Screw
Mounting Base
Enclosure
Dome
②
Unscrew the cover of the dome and then insert a micro SD card.
After that, install back the cover and make sure the cover is installed
firmly.
Insert a micro SD card
Cover
③
Drill the screw holes and the cable hole on the ceiling according
to the drill template. Then route and connect the cables.
Earth wire connection
8
1
2
3
4
5
6
7
1--ALARM-COM
2--ALARM_OPEN
3--ALARM_INA
4--ALARM_GND
DC12V
Ø107.7
Ø5.0
Ø79.4
56.1
56.1
(mm)
*
1
*
2 This series can be powered by DC 12V/PoE power supply. If
the
PoE switch is used
to
power
the
camera, DC12V
power supply
is
not
required
.
It
is
recommended
to
install
the
security
cap
for
outdoor installation
.
*
3
Press
and
hold
the
reset
button
for
more
than
10
seconds
to
restore to the factory default setting.
Security
cap
ALARM-INA
ALARM-GND
Alarm input device
Max.
Load
:
30VDC, 1A
IPC
Relay
ALARM-COM
ALARM-OPEN
-
+
DC
Alarm output
IPC
Alarm output
device
(eg. Switch or sensor)
