Package
Overview
Installation
1
2
3
4
►
Connecting
Network
Cable
①
Loosen
the
nut
from
the
main
element.
②
Run
the
network
cable (without
RJ 45
connector) through the
both elements. Then
crimp
the
cable
with
RJ 45
connector
.
③
Connect
the
cable
to
the
hermetic
connector
.
Then
tighten
the
nut
and
the
main
cover
.
Warning
and
Caution
■
If the product does not work properly, please contact your dealer
or the nearest service center. Never attempt to disassemble the
camera yourself. (We shall not be responsible for any problems
caused by unauthorized repair or maintenance.)
■
Do
not
allow
water
or
liquid
intrusion
into
the
camera.
■
In the use of the product, you must be strict compliance with the
electrical safety regulations of the nation and region. When the
product is mounted on wall or ceiling, the device shall be firmly
fixed.
■
Do
not
use
camera
beyond
specified
voltage
range
.
■
Do not drop the camera or subject it to physical shock.
■
Avoid touching the camera lens.
■
If cleaning is necessary, please use clean cloth to wipe it gently.
■
Do not aim the camera at the sun or extra bright place.
■
Do not place the camera in extremely hot, cold (the operating
temperature shall be -30˚C~60˚C), dusty or damp locations, and do
not expose it to high electromagnetic radiation.
■
To avoid heat accumulation, good ventilation is required for
operating environment.
Quick
Start
Guide
Network
Camera
Camera
Quick
start
guide
CD
Plastic
plug
×4
Drill
template
Screwdriver
Tapping screw
×4
Please make sure that the wall or ceiling is strong enough to
withstand 3 times the weight of the camera.
①
Loosen the fixed screw to disassemble the camera.
②
Open the cover of the dome and then insert a micro SD card.
■
Please read this instruction carefully before operating the
unit and keep it for further reference.
■
All the examples and pictures used here are for reference only.
■
The contents of this manual are subject to change without
notice.
*
1 It
is
recommended
to
install
the
security
cap
for
outdoor installation
.
*
2
If
the
PoE switch is
used
to
power
the
camera, DC12V
power supply
is
not
required
.
Secu
rity C
ap
2
1
3
Fixed Screw
Mounting Base
Enclosure
Dome
DC12V
1
2
3
4
5
6
1
2
3
4
5
6
7
8
Ethernet connector
Audio input connector
Power connector
Mounting base
Fixed screw
Microphone
Micro SD card slot
Reset
7
8
or
Insert a micro SD card
③
Drill the screw holes and the cable hole on the wall according to
the drill template.
Cover
