7
NOTE: Deselecting outputs when a source is going to more than one output is accomplished by selecting the
source (which will then indicate the current output destinations), and then pressing the already active outputs
you wish to de-select followed by pressing the “Take” button. This action will “mute” the selected output(s) but
still maintain the source path to any other destinations you had previously selected. (You can accomplish the
same thing by using the mute function as described above.)
5.2
Control via the Infrared Controller
The included Infrared Remote Controller has three sections of selector buttons that can be
used to control the MX-5288.
NOTE: The front panel buttons will not light up when using the IR remote to control the unit.
Normal matrix functions are performed by pressing
the numbered button of the input you wish to route
from the two rows of “INPUT” buttons followed by
pressing the numbered button(s) of the desired
output(s) from the two rows of “OUTPUT” buttons.
After selecting your preferred input and output(s)
you must press the “TAKE” button on the remote to
make the switch take place.
Pressing any of the numbered “SOURCE SEL.”
buttons will result in that input being sent to ALL
outputs after you press “TAKE”.
If the “TAKE” button is not pressed within 5 seconds
of your initial input selection then all un-taken
remote selections will be cleared.
