Page 23
2.3.
The Control Center
The Control Center contains the ON/OFF switch/Circuit Breaker and the
Keypad
The keypad consists of 3 keys as described below:
UP key
This key has the following functions:
•
In the main screen:
o
This key enables the operator to browse through the cycles.
•
In the menu directories:
o
When the cursor is blinking on a number, the
UP
▲ key increases its
value.
o
When the cursor is blinking on a menu selection, the
UP
▲ key allows
browsing backward through the menu.
o
When adjusting a parameter and the cu
rsor is blinking on “SET” or
“EXIT” the
UP
▲ key activates that procedure.
DOWN key
This key has the following functions:
•
In the main screen:
o
This key enables the operator to browse through the cycles.
•
In the menu directories:
o
When the cursor is blinking on a number, the
DOWN
▼ key decreases
its value. When the cursor is blinking on a menu selection, the
DOWN ▼
key allows browsing forward through the menu. When
adjusting a parameter and the cursor is blinking on “SET” or “EXIT” the
DOWN ▼
key activates that procedure.
START/STOP key
This key has the following functions:
•
In the main screen:
o
Starts the process when the required program was chosen.
o
Stops the current process.
o
Cancels the ERROR message displayed on the screen.
•
In the menu directories:
o
When the cursor is blinking on a number, the START/STOP
key
enables moving to the next position.
o
When the cursor is blinking on a menu selection, the START/STOP
key activates that selection.
