Turf Equipment Z-SPRAY JUNIOR Series, Руководство оператора

Страница: 41 / 64

Maintenance
Maintenance
Note:
Determine the left and right sides of the machine from the normal operating position.
Maintenance Safety
• Park machine on level ground. Disengage the
spray or close the spreader gate, set the parking
brake, stop engine and remove key or disconnect
spark plug wire. Wait for all moving parts to stop
before leaving the operator’s position. Allow
the machine to cool before servicing, adjusting,
fueling, unclogging, cleaning, or storing.
• If you leave the key in the switch, someone could
accidently start the engine and seriously injure you
or other bystanders. Remove the key from the
switch before you perform any maintenance.
• Never allow untrained personnel to service
machine.
• Disconnect battery or remove spark plug wire
before making any repairs. Disconnect the
negative terminal first and the positive last.
Reconnect positive first and negative last.
• Relieve the spray pressure from the system before
servicing.
• Empty the tank and/or hopper before tilting the
machine for maintenance and before storing.
• Keep all guards, shields, switches, and all safety
devices in place and in proper working condition.
Frequently check for worn or deteriorating
components and replace them with genuine Z
Turf Equipment parts when necessary.
WARNING
Removal or modification of original
equipment, parts and/or accessories may
alter the warranty, controllability, and safety
of the machine. Unauthorized modifications
to the original equipment or failure to use
original Z Turf Equipment parts could lead
to serious injury or death. Unauthorized
changes to the machine, engine, fuel or
venting system, may violate applicable safety
standards such as: ANSI, OSHA and NFPA
and/or government regulations such as EPA
and CARB.
WARNING
Hydraulic fluid escaping under pressure
can penetrate skin and cause injury. Fluid
accidentally injected into the skin must be
surgically removed within a few hours by a
doctor familiar with this form of injury or
gangrene may result.
• If equipped, make sure all hydraulic fluid
hoses and lines are in good condition and
all hydraulic connections and fittings are
tight before applying pressure to hydraulic
system.
• Keep body and hands away from pinhole
leaks or nozzles that eject high pressure
hydraulic fluid.
• Use cardboard or paper, not your hands,
to find hydraulic leaks.
• Safely relieve all pressure in the hydraulic
system by placing the motion control
levers in neutral and shutting off the
engine before performing any work on the
hydraulic system.
• Do Not rely solely on mechanical or hydraulic
jacks for support. Use adequate jack stands.
• Carefully release pressure from components with
stored energy.
• Keep your hands and feet away from moving
parts or hot surfaces. If possible, Do Not make
adjustments with the engine running.
• Keep all parts in good working condition and all
hardware tightened.
41