turck TBPN-L5-4FDI-4FDX, Инструкция по эксплуатации

Страница: 26 / 78

Commissioning
Initial commissioning
26
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
7 Commissioning
7.1 Initial commissioning
7.1.1 Mounting and electrical installation
„ Set the F address at the module [ } 28].
„ Please assure the proper closing of the protective cover over the rotary coding switches
[
} 28].
„ Mount the device according to the instructions [ } 16].
„ Connect Ethernet cables according to the instructions [ } 20].
„ Connect the power supply according to the instructions [ } 20].
„ Wire the in- and outputs depending on their use [ } 22], [ } 24].
„
Seal unused connectors with the respective protection caps [
}
19].
Connecting the supply voltage
„ Before the operating voltage is applied, assure that:
- no wiring or grounding errors exist
- a safe grounding of the device/of the application is guaranteed
„ Connect the supply voltage.
„ Check if all supply voltages as well as the output voltage are in the permitted range.
„ Check if the device works properly or if errors are displayed by controlling the diagnostics
an status displays.
7.1.2 Configuring in Turck Safety Configurator
„ Configure the device as described in chapter “Configuring the device” [ } 30].
7.1.3 Commissioning the device at the PLC
„
Configure the device in the PLC.
„
Configure the device in the PLC configuration software [
}
58].
„ Load parameterization and configuration data via the PLC into the device.
„ Execute a functional test.
„ Check if the device works according to the configuration and if all safety functions react
as expected.