turck BL67-GW-PN-AC, Руководство пользователя, Страница: 29 / 119

D301239 1013 - BL67 AIDA PROFINET
4-9
SET-button (CFG)
4.4 SET-button (CFG)
Without function.
4.5 SD-card slot (SD)
Without function.
4.6 Address assignment
4.7 PROFINET operation mode
The gateway BL67-GW-PN-AC is delivered in PROFINET operation mode.
4.8 GSDML-file
The actual GSDML-file for the gateway can be downloaded from the TURCK-home page
www.turck.com.
Attention
In PROFINET, the connected device is not identified by it’s IP address, but recognized and
addressed by it’s device name.
The selection of a device name for a special IO device can thus be compared to the setting of the
PROFIBUS address for a DP slave.
The device name can be freely chosen.
Note
It is not necessary to address the station’s internal module bus.
Note
In order to establish communication between the software I/O-ASSISANT 3 (FDT/DTM) and a
module in PROFINET-mode, it is first of all necessary to assign a valid IP-address to the module
(see
Namenszuweisung BL67-Gateway (page 5-14) ). This can be done for example by using the
HW-Config or the Primary Setup Tool from Siemens).