Turbosmart TS-0101-110X, Руководство пользователя, Страница: 1 / 4

Product Name: All New Boost Tee Manual
Boost Controller
Product Description:
Product Number: Manual Boost Controller
TS-0101-110X
------------------------------------------------------------------------------------------------------------------------
ABOUT THIS PRODUCT
Thank you for purchasing your new Turbosmart Boost Tee. This new model now has some great new features. These include:
• The option of either a slow boost ramp rate for sensitive setups or fast depending on Boost Tee configuration. This is achieved with
either the restricted nipple as well as ball and spring.
•
• A wider boost adjustment range for wastegates with low spring base pressures.
A new mounting bracket to make it easier to mount.
IMPORTANT NOTES ON YOUR BOOST CONTROLLER
Use only silicone hose that is the correct size and pressure rating for your application when fitting your boost controller – other hoses
will be affected by heat and will eventually crack or split which could cause excessive boost pressure and engine damage
•
•
•
•
•
•
Ensure that all plumbing is secured with clamps or cable ties.
Your boost controller should be mounted at least 100mm from any heat source
A Turbosmart Fuel Cut Defender may need to be used in conjunction with your boost controller
– refer to www.turbosmart.com.au
The boost dial has a left handed thread, be sure not to over tighten as this will damage the boost controller.
Please note that the one turn (click) of the boost controller dial does NOT correspond to 1 PSI change in boost pressure.
RECOMMENDATIONS
•
•
•
• Turbosmart recommends that the Air Fuel ratio is checked once boost pressure is set
Turbosmart recommends that boost pressure is set using a Dynamometer and not on the street
Turbosmart recommends that an accurate boost gauge be permanently fitted to the vehicle
Turbosmart recommends that your boost controller is fitted and adjusted by an appropriately qualified technician
------------------------------------------------------------------------------------------------------------------------
HOW TO INSTALL YOUR BOOST CONTROLLER
TOOLS REQUIRED
General mechanic tools
1
Internal Wastegate Setup
Allow the engine to cool down before installing your boost controller •
•
•
Locate the pressure source port and the wastegate actuator port on the turbocharger assembly (refer drawing 1)
Remove the factory boost control solenoid if fitted from the boost pressure supply port while leaving the solenoid connected to the
ECU
•
•
•
•
• Install your boost controller in the wastegate pressure line with the wastegate arrow pointing towards the wastegate actuator
If your wastegate actuator has additional ports, these will need to be blocked
Secure all silicone hose ends with hose clamps
Mount your boost controller bracket onto the vehicle, then attach the boost controller onto the bracket with the supplied screws
Make sure the boost dial is turned completely anti-clockwise before adjusting.
Boost dial Boost Tee
Wastegate actuator port
Pressure source port
(Located before the
throttle body)
Compressor
Housing of Turbo
Note !
Hose clamps/cable ties on all hoses
connections
Drawing 1
1