turbofan E85-12HLD, Руководство по установке и эксплуатации

Страница: 5 / 21

Before Connection to Power Supply
• Remove all packing.
• Check equipment and parts for damage. Report any damage immediately to the carrier and
distributor.
• Remove protective plastic coating from the side panels.
• Check that the available power supply is correct to that shown on the rating plate located on the
right-hand side panel.
E85HLD 110-120 Volts A.C, 60 Hz, 1P+N+E, 1.65 kW, 14.5 A
E85HLD 220-240 Volts A.C, 50 Hz, 1P+N+E, 1.65 kW, 7.2 A
Location
• To ensure correct ventilation for the motor and controls the following minimum installation
clearances are to be adhered to:
Electrical Connection
• E85HLD provers are supplied fitted with cords. Ensure unit is fitted with correct cord and plug.
• To access the electrical connection terminal block, grounding lug and strain relief, remove the
right hand side panel.
WARNING - THIS APPLIANCE MUST BE EARTHED / GROUNDED
Water Connection (Auto Fill Models Only)
• A cold water supply should be fitted to the water inlet (¾” BSP connection) which is located near
the rear of the right hand side of the unit.
• Alternately, a connection elbow and sealing washer is supplied with this unit for direct connection
of a ½” ID hose, and is recommended for easy installation and service.
• Connect water supply - Max inlet pressure 80psi / 550kPa.
• Turn on water supply to check for leaks.
Rack Width
• The E85HLD prover has been designed to accept either 18”
or 16” wide trays.
• The prover comes factory set for 18” trays, to change to 16”
trays:
• Remove the RH side rack (lift and extract).
• Undo the thumb screws (A) holding the RH rack
supports (B) and turn RH rack supports around, then
re-secure with thumbscrew.
3
Installation
Installation Requirements
It is most important that this prover / holding cabinet is installed correctly and that
operation is correct before use.
Installation shall comply with local electrical, health and safety requirements.
Rear 0 mm / 0 ”
Left-hand side 0 mm / 0 ”
Right-hand side 25 mm / 1 ”
A
A
A
A
B
B
B
B
For 18” trays
For 16” trays