Turbo Incanto TIA732, Инструкция по эксплуатации

Страница: 6 / 17

5
2. Installation
Preparing the unit for a built-in appliance
1. Drill a hole on the table surface according to the size shown in the drawing.For the
purpose of the installation and use,a minimum of 50mm space shall be preserved around
the hole.
Be sure the thickness of the table surface should be at least 30mm.please select heat-
resistant table material to avoid larger deformation caused by the heat radiation from the
cooker.As shown in the Figure 1.
2. ATTENTION: important assembly instructions for keeping the induction module cold.
3.
Do not install the hob on top of a refrigerator or dishwasher.If the hob is installed on top of
a drawer put a shelf in between as shown(50mm).If shelves are put in between ensure
that they allow air to flow(30mm).