Tubeline Nitro 275RS, Инструкция оператора и каталог запасных частей

Страница: 23 / 76

Nitro 275RS - Section 4 - Troubleshooting / Maintenance 4-3
Greasing your Machine
• Use only a hand-held grease gun for all greasing.
• Wipe grease fitting with a clean cloth before greasing, to avoid injecting dirt.
• Replace and repair broken fittings immediately.
• If fittings will not take grease, remove and clean thoroughly. Also clean lubricant passageway.
• Replace fitting if necessary.
Notice: Nitro spreaders equipped with grease lines still require seperate greasing and/or oil changes
on gearboxes, front driveline bearing, and PTOs.
Front PTO Driveline CV joint grease points.
NITRO GREASE POINTS SERVICE RECOMMENDATION
Detail A - Three Driveline Pillow Block Bearings Every 10 hours of operation,
2-3 pumps w/ grease gun
Detail A - One Rear PTO Driveline - 2 crosses w/ zerks,
zerk in inner sleeve
Every 25 hours of operation,
2-3 pumps w/ grease gun
Detail B - Two Top Beater Flange Bearings Every 10 hours of operation,
2-3 pumps w/ grease gun
Detail C - One Front PTO Driveline - 2 crosses w/ zerks,
zerk in inner sleeve
Every 16 hours of operation,
2-3 pumps w/ grease gun
Detail D - Two Front Apron Shaft Flange Bearings Every 10 hours of operation,
2-3 pumps w/ grease gun
Detail E - Beater Gearboxs - Two double shaft (outer),
One triple shaft (center)
Change oil every 200 hours / Semi-
Annually w/ SAE 80W90 gear oil - Remove
a cap to check level, top up as needed
Detail F - One Apron Chain Gearbox Change oil every 200 hours / Semi-
Annually w/ SAE 80W90 gear oil - Check
level with sight glass, top up as needed
Detail G - Two Beater Spinner Chain Couplers Every 10 hours of operation, use aeresol
chain lubricant
Jack Follow manufacturer recommendation