Tube-Line NITRO 275RS, Руководство оператора

Страница: 41 / 49

8-1
Section 8 - Optional Flow Control -
Nitro
Section 8 - Optional Flow Control
Flow Control Installation
To install a flow control option follow these
instructions:
NOTICE: Some older machines may require
mounting holes to be drilled out. Place flow
control in desired location on right side of hose
hanger and center punch holes before drilling.
• Slide the 2 provided 1/4-20 x 3 hex bolts
(A)
through 1/4” washers and holes in flow
control body (B) .
• Place the 2 provided 1/2” hex nuts (C) over
the bolt ends to act as spacers between
the flow control and hose hanger.
NOTICE:
Disregarding the spacer nuts may
cause interference between the flow control
assembly and the PTO holder (D) .
•
Secure flow control with provided 1/4” flat
washers and lock nuts (E) .
• Remove 2 existing 30661 hoses (F) from
upper right and middle right bulkhead
fittings
(G) on front of hose hanger.
• Connect 2 existing 30661 hoses to “EX”
and “IN” port fittings of flow control.
• Connect 2 provided 37987 hoses (H)
to flow control “CF” port fitting and bi-
directional flow control hydraulic fitting
(I) .
NOTICE:
The electric flow control option
requires an electric controller (J) installed in
power unit cab. Harness must be routed and
connected into flow control solenoid plug
(K) .
Not applicable for manure spreaders with
scale systems.
A
C
E
B
D
F
G
I
H
K
J