6. SPECIFICATION OF INPUTS AND OUTPUTS
If the USB interface is used to connect a removable device, provide a connector compliant with the USB
standard. This ensures that the pins of the USB interface are connected in the correct order (first shield,
then ground (GND), then V
bus
, then the data lines), thus preventing the interface from getting damaged.
For power supply below 7.5 V, see section
.
6.8.3 Maximum ratings
Symbol
Parameter
Note
Min
Max
Unit
L
max
Maximum cable length
1, 2
5
m
V
usb
Maximum voltage on V
bus
, D+ and D-
-0.5
5.5
V
I
max
Maximum current on V
bus
1000
mA
I
off
Overcurrent protection on V
bus
1000
1600
mA
V
in-CMM
Input common mode range DC or AC-peak with line
frequency (max 60Hz)
3
-0.05
0.5
V
V
in-CMM
Input common mode range DC or AC-peak with line
frequency (max 60Hz)
4
0.8
2.5
V
Note 1
The maximum cable length depends on the type of cable used, the number of con-
nectors between the devices, the environment where the cable is installed, as well
as the used USB transmission speed mode. As a rule of thumb, each connector pair
decreases the maximum cable length by 0.5 meters if a USB conform connector is
used. If an arbitrary connector is used, the length penalty will be higher.
Note 2
A USB high speed (HS) connection is more sensitive than an USB full speed (FS) or
low speed (LS) connection. Hence, the maximum possible cable length also depends
on the kind of peripheral connected to the USB interface.
Note 3
For High Speed USB.
Note 4
For Low Speed USB and Full Speed USB.
6.9 USB Host interface
Supported by Vision 312Plus products.
6.9.1 Pinout
Connector
Pin no./Shield
Function
D
1
USB D+
D
2
USB V
bus
D
3
USB D-
D
4
USB GND
D
Shield
USB SHIELD
© TTControl GmbH 2020. All rights reserved.
Confidential and Proprietary Information
23
Document Number:
D-156-G-02-001
