Page
18
of
41
‘Out of Band’ Control
To allow ‘Out of Band’ control of the PAM1
-IP-3G and/or PAM2-IP-3G, you must first ensure that the Preset
named ‘Under External Control’ is loaded for the corresponding SFP Module
you wish to control, using an
external control system.
‘
Out of Band
’ control allows an external control system to manage multicast subscriptions using the
following protocols:
2110 SFP Module
2022-6 SFP Module
TSL Audio RESTful API
TSL Audio RESTful API
From the
SVIP Main Menu
, navigate to
Stream Config.
1.
Push the rotary encoder to enter the
Stream Config
Menu
2.
SFP1 Module: -
The PAM2-IP-3G displays both the
type (e.g. 2110 or 2022-6) and the firmware version
number of the SFP Module currently inserted into SFP
Slot 1 of the PAM2-IP-3G. If no valid module is present,
the me
ssage ‘pending…’ will be displayed.
3.
SFP2 Module: -
The PAM2-IP-3G displays both the
type (e.g. 2110 or 2022-6) and the firmware version
number of the SFP Module currently inserted into SFP
Slot 2 of the PAM2-IP-3G. If no valid module is present,
the
message ‘pending…’ will be displayed.
4.
Active SFP: -
The name of the currently active SFP
Module is shown. Use of the TAKE and UNDO buttons
provides manual switching between the Multicast Streams currently being subscribed to by SFP1
and SFP2.
5.
SFP1 Preset: -
The name of the 2110 Preset currently loaded into SFP Module # 1 is shown here.
Any one of the SVIP Presets can be manually selected and applied here using the TAKE option.
Please note, when loading a 2110 Preset into the Active SFP, the 2110 Essences associated with
that preset will be displayed immediately on the front panel of the PAM2-IP-3G.
6.
SFP2 Preset: -
The name of the 2110 Preset currently loaded into SFP Module # 2 is shown here.
Any one of the SVIP Presets can be manually selected and applied here using the TAKE option.
Please note, when loading a 2110 Preset into the Active SFP, the 2110 Essences associated with
that preset will be displayed immediately on the front panel of the PAM2-IP-3G.
7.
Press the red button as shown on Page 8 of this Quick Start Guide to exit the
SVIP Input
Selection
Menu.
SVIP Main Menu
Stream Config
Preset Setup
SVIP is selected as the Input Source
SFP1 Signal OK
–
active SFP
No Module Detected in SFP2
Statistics
Module Setup
SVIP Input Selection
2110d v2.2
Under External Control
PTP Setup and Status
2110 Global Options Setup
System Idle
UNDO
TAKE
SFP1 Module
SFP2 Module
pending...
SFP2 Preset:
SFP1 Preset:
Under External Control
UNDO
TAKE
SFP1
UNDO
TAKE
Active SFP:
Содержание PAM1-IP-3G
Страница 34: ...Page 34 of 41 PAGE INTENTIONALLY LEFT BLANK...
