10 Operating QUESTempº 48N
4.
For the
Language
setting, once selected, press
I/O Enter
key. To select a language,
press
Up/Down Arrow
keys. Once selected, press
Run/Stop
key to return to setup
parameters.
5.
For the
Log Rate,
once selected, press
I/O Enter
key.
Repeatedly press
I/O Enter
keys to select either the Log Rate Event or a Log Rate
interval (for data logging; e.g. “5”).
Optional
: changing
Next Event field
. Events are numbered starting at 1 and
incrementing. The number may be increased to simulate skipping events. This may
be useful if the events represent locations and the starting location is somewhere
other than 1.
Event
Example of setting Log Rate to
Event Log
Next event number
*To increase, press up arrow key
(used to simulate skipping an event.)
Log Rate:
event
Nxt event:
11
Figure 1-13: Selecting log rate with event log
6.
For the
Index
setting, once selected press
I/O Enter
key. Press
Up/Down Arrow
keys to
select:
“---” (which is equivalent for no index), ACGIH, PHEL, or Flag.
7.
Exit Setup by pressing the
Run/Stop
key.
Allows printing to a parallel or serial printer or to a computer. The QUESTemp
º
48N Heat
Stress Monitor will recognize the cable plugged in and configure itself for serial or parallel. If
no cable is plugged in, it will default to serial. Press
I/O Enter
key to begin printing. Press
Run/Stop
key to return to the menu.
NOTE:
If you want to stop the printing, press
I/O Enter
key until you return to the main
menu. When the printer has stopped printing, remove the cable from the printer to
the instrument.
Reset
Resetting enables you to clear the logged data from memory. Press the
I/O Enter key
to enter
the
Reset mode
. Clear the memory by holding down the
I/O Enter key
while the display
counts down from three.
