ECHIPAMENTE PENTRU AUTOMATIZĂRI
Electric Film S.R.L. — Aleea Scarisoara 3, Apt.42 ▪ Cluj Napoca, Cluj ▪ 400445 ▪ www.electricfilm.eu
VÂNZĂRI ▪ 0364 710319 ▪ [email protected] ▪ SUPORT TEHNIC ▪ 0788 250583
cele mai sensibile
7
4
.
Install TRP-C38 Hardware
STEP1:
Connect power source with TRP-C38, if power properly supplies the PWR LED will
blinking.
Warning: User can only choose one of 2 power source, external DC-Jack or Screw
terminal DC input. Do not use external DC-Jack and screw terminal DC input
simultaneously.
STEP2:
Connect TRP-C38 with internet port (Ethernet Hub or Switch) by RJ45 LAN cable.
If the cable properly connects the “LINK” LED will light up.
Green: 100MB
Yellow: 10MB
STEP3:
Connect TRP-C38 with RS232 or RS422/485 serial device.
4-1. RS232 Wiring
The RS-232 supports 8 channels plus Signal Ground and is configured as DTE like a computer.
Signals are single ended and referenced to Ground. To use handshaking, Flow Control must be
set to RTS/CTS during Configuration. Refer to the Pin out table for connections.
4-2. RJ-45 LAN Cable Wiring Diagram
PC To TRP-C38: Please use crossover Ethernet cable.
HUB To TRP-C38: Please using straight through cable
