ECHIPAMENTE PENTRU AUTOMATIZĂRI
Electric Film S.R.L. — Aleea Scarisoara 3, Apt.42 ▪ Cluj Napoca, Cluj ▪ 400445 ▪ www.electricfilm.eu
VÂNZĂRI ▪ 0364 710319 ▪ [email protected] ▪ SUPORT TEHNIC ▪ 0788 250583
cele mai sensibile
32
Q
: Why I am unable to change the parameters of port 1?
A
: Serial port 1 is designated console port. The default setting for the console port is 9600 8-N-1.
If the serial port 1 is set to console port. It will use the default value that is why it does response
to the change. Please check hardware switch or server properties page to see if the serial port
mode of the port1 is set to console. Please change it to other mode then its parameter can be
changed.
Q
: Why the parameters in the web console are different than those in the server properties of
management utility?
A
: The edited parameters in the web console only take effect after reset TRP-C38. Web console
show the edited configuration while in the management utility show the running configuration.
That is why they might appear differently it is not recommended to edit server's configuration
using two different tools at the same time. Because all change could be over-written by other
method.
