TruSteel AutoVap30, Руководство пользователя

Страница: 21 / 39

TruSteel AutoVap30 User Manual | | v. 1.9
21 / 39
Close the feed line ball valve on the grey/orange recycle valve
3. CHANGE FROM EXTRACTION MODE TO RECYCLE MODE
Locate
“SYSTEM MODE” on the HMI Home Screen
Press
“EXTRACTION”. It will change to “RECYCLE”
This will activate an electronic 3-way ball valve.
This will also reverse the direction of the feed pump.
Once the
“VALVE IN MOTION” light stops flashing, you can continue.
4. START FEED PUMP
Press START on the HMI under FEED PUMP
5. SET RECYCLE MODE SETPOINTS
On HMI Home Screen, Locate
“RECYCLE MODE SETPOINTS”
Adjust the speed of the motor, which translates to the amount of pressure is in the
preheater section of the system.
Recycle mode speed should be around 15-25 Hz which equals to around 30-60psi
6. ADJUST
“SHUTDOWN PSI”
It is important to adjust the PSI shutdown pressure properly so the feed pump does not run
dry.
Set the
“PSI SHUTDOWN” to 1-2 PSI higher than the lowest preheater pressure reading
on the display throughout RECYCLE MODE.
7. DRAIN RESIDUE FROM SYSTEM
Put the RESIDUE PUMP into MANUAL OVERRIDE Mode and manually discharge the
residue material from the system.
You are now ready to run CLEAN MODE on your AutoVap System.
SECTION VI: CLEAN MODE
The cleaning cycle is a very important step in operating your AutoVap30. This cycle should be
performed at least every 8 hours of operation, even if you are continuously operating. It is
extremely necessary to run a cleaning cycle before shutting down the AutoVap30.
Solvent cleans the oil out of the AutoVap and distilled water cleans plants sugars and gums that
are left behind.
Failure to run cleaning cycles can result in pump failures and may produce clogs in your
AutoVap30 system. If it is determined that you are not performing regular cleaning and
maintenance on your AutoVap system, warranty may be voided and parts, such as new pumps,
will have to be purchased by the customer.
To properly clean the AutoVap, we highly recommend a 3-Stage Cleaning Process: