8. Control the penetration depth of the punch with the setting
gauge (TRUMPF order no. 1411767).
9. Close the locking mechanism (1).
Changing the die and punch guide
1. Unscrew and remove the screws (6).
2. Clean the support areas on the die carrier (3).
3. Clean the replacement parts if necessary.
Use lubricating grease "G1" for lubrication (TRUMPF order
no. 139440).
4. Lubricate the guide surfaces of the punch guide.
5. Tighten the screws (6) (torque 20 Nm).
Use only original spare parts from TRUMPF.
The punch can be reground by a total of approx. 10 mm.
Observe a minimum length of 89 cm: shorter punches must
be replaced (risk of collision).
20
Replacing the tool
2011-04
E528EN_06
