Trumpf TruSystem 7000, Руководство по обслуживанию

Страница: 251 / 306

Cable W157
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
251
22.9 Cable W157
Disassembly 1. Prepare the operating table (see chapter 7 on page 29).
2. Secure the star wheel (#1800121) on the left side rail
26)
of
the seat section.
Release the brake on the operating table (unlock the
operating table).
4. Switch off the operating table and disconnect the internal
power supply (see chapter 10 on page 33).
5. Slide the multifunction tool [1] mounted as a T under the table
base [2].
6. Safety note: The operating table is extremely heavy; take extra
care not to strain your back when turning it on its side. A
second person is needed to turn the operating table on its side.
With the help of another person, lay the operating table over
onto the multifunction tool (side with the column keypad points
down) and set it on the star wheel.
After placing the table on its side, do not activate the
hydraulics system to prevent air from seeping into the hydraulic
hoses.
7. Remove the left cover [3] under the table base (4 screws).
8. Important: the assembly is attached to the cover. Provide a
suitable aid (for example a crate or carton) near the table
base so the assembly can be placed on it. The cables are not
long enough for the assembly to be placed on the floor.
Remove the center cover [4] under the table base (4 screws
with washers) and store it carefully.
26)
Side with the column keypad
3.
CAUTION
Risk of material damage!
The major force required to turn the table on its side can break
the extended foot locks of the brake. The operating table must
be unlocked before turning it on its side.