Trumpf TruConvert DC 1000 Series, Руководство оператора

Страница: 94 / 112

8. Process set values
8.1 Set process set values
1. Either
Ø To set the set values for a single DC-DC module: Enter
the number of the slave in the "Slave Module Selection"
area under "Slave Number".
or
Ø To uniformly set the set values for all DC-DC modules:
set the "Slave Number" = 0.
2. Set the lower and upper limit up to which the battery is dis-
charged or charged, respectively.
−
User interface:
Select >
Operation > DC Settings .
Set the following in the "DC Settings" area:
For "DC Voltage Limits", enter:
"Minimum Battery Voltage [V]": lower limit, up to which
the battery is discharged.
"Maximum Battery Voltage [V]": upper limit, up to which
the battery is charged.
− Modbus:
(see "Tab. 7-6", pg. 7
‐
14)
3. Set the lower and upper alarm limit.
− User interface:
Enter the limit values for the DC-DC module in the "DC
Voltage Error Thresholds" area:
For "DC Voltage Limits", enter:
"Minimum Battery Voltage Threshold [V]": lower limit, up
to which the battery is discharged.
If this value is not met (e.g., due to short circuit of the
battery), the TruConvert System Control generates an
alarm message.
"Maximum Battery Voltage Threshold [V]": upper limit, up
to which the battery is charged.
If the value is exceeded, the TruConvert System Control
generates an alarm message.
− Modbus:
(see "Tab. 7-6", pg. 7 ‐ 14)
− Select the values so that they lie outside of the "DC Volt-
age Limits" control range.
4. Enter limit values for the charging and discharging current.
7 ‐ 26
Process set values 2020-07-01 A67-0140-00.BKen-0
01-05