Trumpf BendMaster 150, Руководство оператора

Страница: 199 / 258

6.16 Connection to storage (option)
The TruBend Cell 5000 can be linked to a storage system.
The stack positions must be booked correctly in the warehouse
management software, (e. g. TruTops Fab). The image recogni-
tion alone is not sufficient.
Parts automatically requested from the storage system by the
BendMaster may be set down on the storage pallet only as indi-
vidual stacks . The stack must not include any parts of a differ-
ent job.
The operator must observe the following:
■ The BendMaster must not collide with neighboring stacks on
the storage pallet when picking up a part.
■ The stack height must not exceed the permissible maximum
value when returning processed parts to storage.
Defining parts data
1. Press > Set up > Job menu.
2. Enter the "parameters", "lot size" etc.
3. Press
Parts data .
4. In the drop-down menu, press Unprocessed material , Fin-
ished part or, if available, Intermediate layer part .
The selected parts data is displayed and can be entered
(see "Tab. 4-9", pg. 4
‐
55) , (see "Tab. 4-10", pg. 4
‐
55) , (see
"Tab. 4-9", pg. 4
‐
55) .
■ The material designation must be known to the storage
management.
■ Observe that the entries are case sensitive.
Defining loading and unloading areas of
the storage stations
1. Press > Set up > Areas menu.
2. Define the loading and unloading areas. The control sends
the entries directly to the storage management program:
B579EN
2015-06-01 Running in a TruTops program
4
‐
105