Trumpf BendMaster 150, Руководство оператора

Страница: 195 / 258

Fig. 40877
4. Press Start in the "Program" field. The job under the job
name is started.
The active execution of a job is indicated by the green light
of the signal lamp on the safety fencing.
5. Press Stop in the "Program" field if the execution of the job
is to be interrupted immediately.
6. Press Resume in the "Program" field if the interrupted job is
to be further executed.
The number of blanks on the loading stack, below which a warn-
ing information is issued, can be programmed.
7. Enter the corresponding quantity in the "Advance Warning
Sheets Load".
Starting with this number, the text "Advance warning Sheets
Load" will be displayed in red. At the same time, the white
signal lamp on the safety fencing is switched on.
The number of available free deposit places below which a warn-
ing information is issued, can be programmed.
8. Enter the corresponding quantity in the "Advance Warning
Sheets Deposit" field.
Starting with this number, the text "Advance warning Sheets
Deposit" will be displayed in red. At the same time, the white
signal lamp on the safety fencing is switched on.
9. Press Position .
10. Press Stack (see "Defining stacks", pg. 4
‐
78) .
11. Press Messages .
12. Press Source text (see "Program, loading", pg. 4
‐
92) .
13. Press Empty unloading area .
B579EN
2015-06-01 Running in a TruTops program
4
‐
101
Advance warning, number of
blanks below minimum on
loading stack
Advance warning, free
deposit places below
minimum
Having the axis position
displayed
Switching to "Stack
assignment"
Switching to "Diagnostics"
Switching to "Run in"
Emptying an unloading
stack