Trumpf BendMaster 150, Руководство оператора

Страница: 188 / 258

Program step Description
BEND_SHEET Sheet bending subroutine.
UNLOAD_SHEET Store part subroutine.
Tab. 4-26
Selecting an execution method
Jobs can be loaded either in continuous operation mode or step-
by-step. Continuous operation is activated by default.
1. To run in the program step-by-step: press Stepping . The cur-
rent program step is displayed on a yellow background:
or
Ø Press Cont to return to continuous operation.
2. Press the green START key on the portable manual control
unit.
Note
When running in step-by-step, each program step must be
started using the green START key on the portable manual
control unit.
3. If a program is to be executed only up to a specific program
point:
−
Interrupt the program at the portable manual control unit
using the red STOP key.
− Press Stepping .
− Mark the program point at which the program is to be
interrupted.
− Press Operation , Set Breakpoint .
− Press Operation , Activate/deactivate Breakpoint . The pro-
gram is only interrupted at the breakpoints indicated by
checkmarks.
− If required, press Set PC .
− Press Operation , Go to breakpoint . The program is exe-
cuted up to the active breakpoint.
− Press Operation , Remove all breakpoints to delete all
active breakpoints.
4. To interrupt the running-in process, press the red STOP key
on the portable manual control unit.
Running in procedure
■ The press brake is started.
■ The press program is loaded by the industrial PC.
4
‐
94
Running in a TruTops program 2015-06-01
B579EN