Trumpf BendMaster 150, Руководство оператора

Страница: 183 / 258

Note
When a program is run in, the parameters for bending support
and for approaching the backgauges are not yet defined. After
crossing the bend for the first time, the default parameters stored
in the control are entered. Due to the fact that the averaging fil-
ter cannot be adjusted by personnel, this parameter has no
default value even after crossing.
Opening bending parameters
1. On the "Separation method" screenPress Continue .
or
Ø press > Set up > Bending parameters .
Fig. 49448
Note
The Backstop resistor field is displayed only for activated
backstop resistors.
2. Use the following buttons to select the bending which is to
be modified:
Name Description
> Go forward one bending step from current bending
step.
>> Go to last bending step.
< Go back one bending step from current bending step.
<< Go to first bending step.
Tab. 4-25
B579EN
2015-06-01 Running in a TruTops program
4
‐
89