Trumpf BendMaster 150, Руководство оператора

Страница: 171 / 258

Intermediate layer, searching for
Condition
■ Intermediate store has been programmed in TruTops Bend
(function available from TruTops Bend V4.15).
1. Switch to the > Run in > Area menu.
2. Mark the loading area for the intermediate layer (orange).
3. Press
Search within area .
The intermediate layer area is searched. Depending on the
size of the area, several images are recorded. The first
image is displayed.
4. Position the blue cross-hairs from the top left corner of the
screen at the point where the height is to be measured and
the stack is to be searched for.
5. Press Find stack or Search within area to search for the
stack.
Procedure in the event of problems with
the rough recognition
1. In the > Set up menu, press Apply areas .
■ Height measuring point was not defined properly.
■
Stack is not entirely in the search area.
2. Use Search within area .
3. Search for several stacks with separate individual loading
areas.
4. Reduce the size of the loading area, if possible.
5. Search for several stacks with separate individual loading
areas.
6. Use Search within area .
7. Change the height measuring point.
■ Height measuring point was not defined properly.
■
The pallet height is incorrect in the > Set up > Areas menu.
■ An incorrect stack height was entered during rough recogni-
tion.
8. In the > Set up menu, press Apply areas .
The height measurement is a relative measurement between the
BendMaster and the highest blank. For this reason, minimum
deviations may occur between the actual and measured stack
heights.
B579EN
2015-06-01 Running in a TruTops program
4
‐
77
Incorrect area is scanned
Stack not found
Part of the composite image
is overexposed or
underexposed
Stack is not found properly
Height measurement not
successful
Incorrect stack height