5
inserting/rePlacing the nozzle
Insert the nozzle into the opening at the top of the flosser. When correctly inserted
you’ll hear a click.
To remove the nozzle from the handle, press and hold the nozzle release button and
pull the nozzle out.
The nozzles can be swivelled 360°.
The box includes the following nozzles:
−
Standard Jet
– used to rinse hard-to-reach areas and places where a conven-
tional toothbrush cannot reach.
−
Orthodontic Jet
– a special orthodontic nozzle designed to clean and rinse
hard-to-reach areas around braces.
−
Periodontal Jet
– directs the stream of water or mouthwash below the gum
line thanks to the tapered silicone end.
−
Dental Plaque Jet
– used for more effective removal of dental plaque with
easier access to affected areas.
Note:
Only insert and remove the nozzles when the flosser is switched off.
Note:
Nozzles are subject to personal hygiene and are not subject to warranty.
rePlacing the Battery in the handle
The handle is powered by an AAA battery. When the controls stop working, it means
the battery is dead and needs to be replaced.
Follow the instructions below:
1. Use the special opener to open the cover on the bottom of the handle.
2. Replace the battery with a new one.
3. Close and secure using the opener again.
We recommend removing the battery from the handle if you are not using the devi-
ce for an extended period of time.
Maintenance
Use only water and neutral detergents for maintenance purposes. Never use caus-
tic or abrasive cleaners as they can damage the equipment. Do not use water at
temperatures above 50°C. Keep the equipment away from high temperatures and
avoid direct sunlight.
1. Base
Remove dirt by wiping it down with a towel or cloth with liquid soap and water. Then
wipe it dry. Do not immerse the device in water.
2. Water reservoir
Wash the reservoir with water and wipe with a dry cloth.
Dry the reservoir thoroughly if you are not going to use it for a long time.
