BKL01001
Page 2
IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!
TO EXPEDITE ANY FUTURE WARRANTY CLAIMS, PLEASE KEEP INSTRUCTION SHEET, WARRANTY CARD AND RECEIPT
PARTS LIST
DESCRIPTION
A
B
C
D
E
F
G
H
BOLT COVER
HEX BOLT DRIVER
TABLE LEG
LEG CONNECTOR
BRACKET
GLASS TOP
FOOT CAP
FACTORY ASSEMBLY
* NOTE: PARTS SHOWN ON PARTS LIST ARE NOT TO SCALE
Ø6.5 X 1.0 MM
WASHER
Figure 1
Step 4:
Note:
Do not over tighten
After making any necessary adjustments to the
alignment of the table base and table top, use the hex
bolt driver to tighten all bolts.
each bolt must
be tightened a few revolutions at a time. In order to
apply equal pressure to all bolt joints, we recommend
working in a cross corner (X fashion). Repeat until
all bolts are tight.
. Over
tightening may strip bolts. Cover all bolts with covers.
With the help of another person, turn the table in the
upright position. Note the table bumpers spaced
evenly throughout the inside of the rim. Carefully
place glass inside the rim, resting on the table bumpers.
Your table is now ready for use.
Step 5:
Figure 2
Step 1:
Remove all protective materials and set parts on a flat,
non-abrasive surface. Identify parts packed in carton
against the parts list.
Step 2:
Hand tighten only 2-3 turns.
Attach a leg to the leg connector bracket by using a bolt
and washer as shown in
. Guide the bolt through
the hole in the leg,
leg
connector bracket.
Repeat
for the other legs.
F
1
into the pre-drilled hole in the
igure
Step 3:
Place the table rim upside down on a flat, non-abrasive
surface.
igure
Attach a table leg to the table rim by using two
bolts and washers as shown in
. Guide the bolts
through the holes in the table leg into the pre-drilled
holes in the table rim.
Repeat for the other legs.
F
2
Hand tighten only2-3 turns.
1/4" X 20 MM BOLT
E
G
F
B
ORDER PART # QTY
1
1
1
4
12
12
12
HW0105
HW0004
HW0006
FC0069
HW0036
TABLE RIM
1
G0199
TABLE BUMPER
FACTORY ASSEMBLY
FOOT CAP
D
C
E
G
F
ST1907
ST1908
ST1909
