Tru-Test WaterWell 2, Руководство пользователя

Страница: 11 / 40

11
d Slide the water supply insulation tube over the ¾ inch flex line and vertical water supply line, making sure that the
insulation tube reaches up to the valve.
0
Step 6: Preparing the tank
a Turn the tank on its side.
b Apply the foam tape 1 to position 1 on the bottom of the tank, around the outside edge (recessed channel), of the hole on
the bottom of the tank (where the thermal earth tube will align).
c Apply the foam tape 2 to position 2 on the bottom of the tank, around the outside edge (recessed channel).
d Foam tape 3 is pre-installed under the tank top lid, and no further installation is required.
e Finally, apply the foam tape that shipped with the reservoir lid.
f Unscrew the WaterWell valve or disconnect it from the tank. Remove the valve mounting plate assembly by unscrewing
the three hex bolts.
g Lift the tank and carefully place it over the vertical water supply line and ¾ inch flex line, so that the ¾ inch flex line comes
up through the tank top opening. The end of the ¾ inch flex line should be 2-3 inches above the opening. This allows
room to make connections to the valve. Excess line will be pushed back down into the tank bottom later.