Tru-Line TLT Series, Руководство по эксплуатации и обслуживанию

Страница: 9 / 33

9
Calibrating the toe settings for TLT-36 right Laser Gun
and TLT-37 left Laser Gun.
1) Place the TLT-41 Calibration Bar on a firm surface orientated so that the end of
the bar that has the mounting discs on it is opposite of a clear distance of at least
twenty (20’) feet. Hang a laser gun on one of the discs of the TLT-41 Calibration
Bar. Level the laser gun and turn it on pointing towards the clear distance of at
least twenty feet (20’) away. Zero the Toe Dial.
2) Go out a distance of at least twenty feet (20’) and place one of the Centering
Target Flags so that the Target Scale is level with the laser gun.
3) Remove the Laser Gun and replace it with the TLT-51 Calibration Laser. Once
the TLT-51 Calibration Laser is on the disc, turn it on and point it at the Centering
Target that is twenty (20’) feet away.
4) Adjust the Centering Target Flag so that the laser beam from the TLT-51
Calibration Laser is on either the #2 or #11 of the Centering Target Scale.
5) Remove the TLT-51 Calibration Laser and place it on the opposite disc. Point the
laser beam at the Centering Target Flag and make note of the number it is on,
either the #2 or #11. The TLT-41 Calibration Bar is now on center with the
Centering Target Flag.
6) Remove the TLT-51 and hang both Laser Guns (TLT-36 & 37) on the discs of the
TLT-41 Calibration Bar and secure them by gently pressing down on the laser
gun. There should be a slight snap when the plunger locks into place on the disc.
Level them at the Centering Target Flag; turn them on and set the Toe Dials on
Zero.
7) Make note of where the laser beams hit the Centering Target Flag that is Twenty
(20’) away. I.E. the #2 and #11. Take the other Centering Target Flag and place it
in front of the laser beams at the end of the Laser Guns.
8) Make note of where the laser beams hit the Centering Target. Note: You may
have to flip the Centering Target upside down in order to read the target on the
same numbers as the far target.
9) If the distance marks on the near Centering Target is not the same as the distance
mark on step 7. Adjust either, one or both Toe Dials until an equal distance mark
is obtained both at the near reading in step 8 and the far reading in step 7. I.E. if
the Left Laser Gun hits the #1.5 on the far Centering Target and the Right Laser
Gun hits the #11, and on the near Centering Target the Left Laser Gun hits the #2
and the Right Gun hits the #11. Then only the Left Laser Gun would have to be
adjusted to make the laser beams parallel.
10) In case an adjustment is required. To reset the dial ring to zero, (Fig. 7) on the
scale of the laser box. Loosen the two 1/16 hex screws on the toe knob enough to
move the dial ring freely. Now tighten the hex screws.