Tru-Line TLT Series, Руководство по эксплуатации и обслуживанию

Страница: 24 / 33

24
3. Hang the gauge on the black side and read the camber.
4. Adjust the bubble half way back using the camber zero adjust knob. The camber
gauge now reads the tilt on the ground.
1. Place the gauge on the red side and read the tilt of the ground. Whatever the
SAI/KPI readings are, add the ground tilt reading on the right side, and subtract
the reading on the left side. IE… If the tilt of the ground is 1deg and the right side
reading is 12 deg`s, and the left side reading is 14 deg`s, the corrected readings
would be 13 deg`s on the right and 13 deg`s on the left.
To Measure Front to Rear Tilt for Caster
Caster readings are affected by front to rear tilt of the vehicle. The following procedure
compensates for the tilt to give full accuracy caster readings. You can measure caster first
by following this procedure.
1. Place the bar along the side of the vehicle. Make sure the ground is reasonably
flat (not level) so the bar is tilting about the same as the vehicle. Place the bar on
the driver side of the vehicle with the red side toward the front.
2. Hang the gauge on the red side and zero the camber bubble using the camber zero
adjust knob (refer to Figure 6).
3. Hang the gauge on the black side and read the camber.
4. Adjust the bubble half way back using the camber zero adjust knob. The camber
gauge now reads the tilt on the ground.
Place the gauge on the red side and read the tilt of the ground. Whatever the caster
readings are, add or subtract the ground tilt reading to the caster reading.
Figure 20