Lighting Technologies TRQ, S. L.
SELF CONTAINED EMERGENCY SIGN
F
IP40
SERIE I-SIGN y VIZART
Technical Characteristics:
-
Supply 230V~ 50/60Hz.
-
Maintained.
-
Stand by and re-start via Telemando(TM).
-
Green Led indicating, the Battery re-charging.
-
Illumination via High luminosity white led.
-
Stabilized current of Led (constant current control).
-
Visibility 24 mts. (As per NORM UNE-EN 1838).
-
Autonomy superior 1 hour.
-
Battery Ni-Cd 6V – 0,8Ah.
-
Protection Grade IP40.
-
Connection via
∅
6 mm cable.
-
Overload & end of battery discharge protection.
-
Class I Luminary.
-
Pmma Diffuser of 8 mm width.
-
Aluminum front frame in 2 colors: White & Black ( ISIGN) and White & Aluminum ( VIZART)
-
Surface and wall recessed mounting.
-
Pictograms & mounting accessories included.
Norms Applied:
-
CE marked as per 2006/95/CE y 2004/108/CE UNE-EN 60598-2-22
-
UNE-EN 60598-1
-
UNE-EN 1838
Installation:
-
Install the luminary following the mounting instructions on the next page and electrical connection
diagram.
-
Switch On the Power and verify that the Pictograms and the green led indicating the battering
charging are illuminated.
-
The Luminary will not respond to its complete autonomy until 24 hours, as the batteries are supplied
Discharged.
-
If during working, the frontal diffuser is disconnected, the luminary will be blocked, to reset, first
disconnect the luminary from the power supply , then the battery, wait for few seconds and connect
first the battery then the power.
Maintenance
:
-The Batteries should be changed once their duration gets inferior to the assigned.)
-The Batteries and the electronic components should be re-cycled or eliminated in an adequate way.
-Before doing any maintenance operation, please make sure that the Main supply is switched off and the
luminary is in STAND BY Position.
Telemando TM: TM is used for verification and also for standby / restart in emergency mode
Connection Diagram:
A:
Connection without Telemando.
B:
Connection with Telemando.