1mm
Elevator
Tailing
edge
Make sure they are in
the right position while
installing.
4mm
4
Wood dowel (4x30mm)
2x7mm
2x7mm
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
3mm
1
Stab joiner (10x240mm)
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
Keep some space about 1mm width between
elevator and tailing edge.
Drill two holes at the stabilizer root base via rib template
and epexy the wood dowel in them.
Drill holes to appropriate position in the stabilizer .
Glue the elevator to the stabilizer by CA and epoxy.
Make sure hinges are
mounted in the same line.
6
Pin hinge(24x24mm)
3mm
Apply instant type CA glue to elevator and pin hinge.
Assemble the stablilizers carefwly to fuselage.
27
28
29
30
32
6
31
7
Ply(15x15x3mm)
35
TP Screw (2.3x8mm)
1
Canopy
B'
A
A'
B
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Temporarily fasten down the main wing and
check its correct position.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
A = A '
B = B '
1
Former
90mm
90mm
14
Washer (3x6mm)
4
TP Screw (3x10mm)
Washer (3x6mm)
1.5mm
152mm
1
Former
28
TP Screw (2.3x8mm)
14
TP Screw(3x20mm)
4
Exhaust
Exhaust
Trim the cowling for engine and muffler.
Assemble the tail wheel to the tail landing gear.
Assembly of the stabilizer.
Epoxy the former to appropriate position in the cowling.
Assemble the exhausts to appropriate possion
on the fuselage with screw as below.
56
55
58
11
57
59
Accessory list for the coming installation steps.