A = A '
A`
A
6mm
2
Wood dowel (6x30mm)
1
Rib template (2mm ply)
Rib template (2mm ply)
Main wing joiner
1
20mm
100mm
60mm
R10mm
R10mm
6mm
Rib template (2mm ply)
2
Wood dowel (6x50mm)
50mm
6mm
According to the rib template drill holes to another
main wing.
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
The sketch map when the main wing
assembled completely.
Trim holes in the appropriate position in the mid wing
and drag the servo wire and the air tube out.
According to the rib template drill holes in one wing and
epoxy wood dowel in them.
Epoxy the main wing hardly together with wing joiner.
Drill holes to appropriate position in the front of mid
wing and epoxy wood dowel in them.
Air tube
Servo wire
17
18
20
21
4
16
19
TP Screw (3x20mm)
Wooden Block
TP Screw (3x20mm)
Collar (5mm)
Wooden supporter
Collar (5mm)
Washer (3x6mm)
Wooden Block(43x28x26mm)
1
Gear door
2
4
Collar (5mm)
Wheel (100mm)
Landing gear(5mm)
2
1
12
2
TP Screw (3x20mm )
Landing gear straps
8
Washer (3x6mm)
4
Wooden Block(25x15x13mm)
21mm
Throttle servo
switch servo
Rudder servo
Elevator servo
21mm
Assemble the wheel and gear door to landing gear.
Assemble the receiver and the battery to appropriate
positon in the fuselage.
The servos installation finished sketch map.
Cut off the surplus shaded portion carefully from
the fairing below.
Epoxy the fairing parts to appropriate position in
the fuselage and mid wing.
69
65
13
Accessory list for the coming installation steps.
67
66
68