Troy-Bilt Storm 2410, Руководство оператора

Страница: 8 / 56

8 S
ection
3— A
SSembly
& S
et
-U
p
2. Close the flange keepers to secure the chute assembly
to the chute base. The flange keepers will click into place
when properly secure. See Figure 3-4.
NOTE:
If the flange keepers will not easily click into place,
use the palm of your hand to apply swift, firm pressure to
the back of each.
Figure 3-4
Chute Directional Control (Model 2410)
1. Remove the plastic cap (if present), flat washer and hairpin
clip from the end of the chute directional control. See
Figure 3-5.
Figure 3-5
2. Insert the end of the chute directional control into the
lower bracket and secure with the flat washer and hairpin
clip just removed. If necessary, the lower bracket can be
adjusted. Refer to Chute Bracket Adjustment on Page 19.
Chute Assembly and Directional Control
(Models 2620 and 2840)
1. Remove cotter pin, wing nut and hex screw from chute
control head. Remove clevis pin and bow-tie cotter pin
from chute support bracket. See Figure 3-6.
Chute Control Head
Chute
Chute Support
Bracket
Chute Base
Figure 3-6
2. Insert chute control rod into chute control head. Push rod
as far into chute control head as possible, keeping the
holes in the rod pointing upward. See Figure 3-7.
Figure 3-7