22
BE-LCD-01 Operating and Installation Manual / Leaflet no. M375EV8 (01/2015)
6 Installation and electrical wiring
Mounting on an adapter
How to proceed
1.Create a cut-out and drill any necessary holes
into the side frame or furniture wall.
2.Lay the cable for the connection of the control
panel with the controller. Take the control panel
end of the cable and pass it carefully from the
rear through the side frame. Only the plug must
protrude from the side frame cut-out.
Attach the first cable fastener in such a way that
some spare cable length remains inside or at the
end of the side frame.
3.Feed the cable through the adapter from below.
Attach the adapter to the side frame or furniture
wall using suitable screws.
After fixing the screws, check the connecting
cable for any damage. To do so, pull the
connecting cable about 35 cm out of the side
frame and check it.
4.Put the plug of the connecting cable into the
socket of the control panel such that it locks into
place. → See picture on p. 23
5.Align the control panel including the cable with
the adapter and press it onto the fixing points until
it locks into place. In the process, carefully push
the connecting cable back into the side frame
cut-out without kinking it.
Wall installation using a junction box
How to proceed
1.Install the junction box.
2.Lay the cable for the connection of the control
panel with the controller. Take the control panel
end of the cable and pull it from the junction box
for about 10 cm.
3.Carefully remove the control panel base plate:
The release openings are located on the left side
of the casing. Fix the base plate to the junction
box.
4.Put the plug of the connecting cable into the
socket of the control panel such that it locks into
place. → See picture on p. 23
5.Align the control panel including the cable with
the base plate and press it back onto the base
plate until it locks into place. In the process,
carefully push the connecting cable back into
the junction box without kinking it.
Right-hand side
frame
Left-hand side
frame
Above the sash
Below the sash
Adapter
Side
frame
Connecting
cable
Base plate
Junction box
Connecting
cable